Note: This link for EU 868.42MHZFrequency (EU).
FIBARO – Z-Wave Universal sensor FGBS-001
The Universal Binary Sensor from Fibaro is a wireless module that makes it possible to improve the functionality of any sensor with a binary output by allowing it to communicate with the wireless Z-Wave network and the Z-Wave Gateway. Moreover, the module allows for wireless communication between the system and the DS18B20 temperature sensors. The device can service up to two binary sensors and up to four DS18B20 temperature sensors.
The Sensor was designed for installation in the housing of a sensor or another device, the functionality of which we wish to improve. The Universal Binary Sensor may be used whenever wireless collection of data from sensors is required. Once additional safety housing have been installed, the Sensor can also be used in areas with high humidity and high temperature. The Sensor’s main function is the integration of the wireless Z-Wave System with the existing wire-based and wireless alarm and measurement systems. As an element of the safety system the device is transparent for parametric alarm lines.
- Small form factor
- Optimized antenna range
- Ease of use and installation
- Integrates with all certified Z-Wave controllers in Australian version (921.42MHz) including: HomeSeer, VERA 3 and Lite, Schlage LiNK, Fibaro HC2, MyNevo S70 and Q50, DHS Z-Wave Universal Remote Controller, DHS Z-Wave Mini Remote Controller
|RF Protocol||Z‐Wave (Multilevel Command Class)|
|Z‐wave device type||Z-wave binary sensor, slave|
|Power||9-30V DC ±10%|
|RF Frequency||921.42Mhz ‐ AU/NZ approved RF for Z‐wave|
|Operation Range||Up to 15m indoor when no obstacles|
|Operation temperature||0 ~ 40 °C|
|Storage temperature||‐10 ~ 80 °C|
|Measurement range||-55C – +126C|
|Regulatory Compliance Mark||N5496|