Note: This link only for EU 868.42MHZ Frequency (EU).
FIBARO – Z-Wave Dimmer 2 FGD-212
Using the unique, specially designed algorithm, Dimmer 2 recognizes the type of a connected light source and calibrates itself to set proper values. Now you can be sure that lights in your home are controlled in the optimal way.
Compatible with both 2 and 3 wire systems
The Dimmer 2 is designed in such a way that it can be used in both 2 and 3 wire electrical systems, so you can use it in older electrical systems as well.
The new Dimmer 2 features power metering functionality.
You can view the energy consumption of your home in clear charts and graphs, and use it to reduce your energy consumption and monthly bills as well.
Control various light sources
The Dimmer 2 is an extremely advanced device, the first on the market to offer the possibility to control both the leading edge and the trailing edge. Now you are free to choose a light source and fully control it any way you want.
Configure the lights as you wish with Dimmer 2 and the creative use of scenes. Imagine that in the middle of the night you need to go to the kitchen. You turn the lights on – and you’re blinded. Sounds familiar? With Dimmer 2 the lights will turn on slightly dimmed, gently illuminating your way.
Dimmer 2 offers an extremely intuitive scene management. The device will turn one of the light switch buttons into a scene trigger. Activating a selected scene becomes as simple as turning the light on. Just press the button while entering the room and all lights will be dimmed to the correct degree for a defined lightning atmosphere!
The Dimmer 2 incorporates a number of security features protecting the device from overheating, overload and voltage drop. Should any of these security features happen, you will be notified immediately.
New intelligent Bypass 2
To increase the possibilities of the Dimmer 2 even more Fibaro has designed the new, microprocessor controlled Bypass 2.
More convenient connectors – Easy installation
The Dimmer 2 is equipped with large connecting terminals which simplify the installation process. You can connect it to wires of a larger diameter and make the installation faster.
User-friendly configuration menu
The built-in RGB diode is a perfect source of information during the installation process. It will show you when the Dimmer 2 has been included to or excluded from the network. You will see whether the calibration or software update has successfully completed. You can also check the Z-Wave network range.
Z-Wave range tester
Use the Dimmer 2 to test the Z-Wave network range. The built-in RGB diode will help you see if the place in which you chose to install the Dimmer 2 stays within the direct range of the Z-Wave network.
You can update the software to its new version whenever available. This way you will always benefit from any new functionalities without the need of purchasing new device.
– Automatic Detection of a light source through advanced internal calibration
– Power Metering
– Compatible with 2 and 3 wire electrical systems
– Supports both leading and trailing edge
– Newest generation
– Powerful 500 Z-Wave Chip
– Z-Wave Plus protocol
– Built-in scene activation
– Security and Notification class
– Configuration menu with LED
– Complete DEKRA and Z-Wave Certification
– Maximum output of 250W
Voltage: 110 – 240V AC
50 – 250W Resistive
50 – 225VA Resistive-Inductive
50 – 200VA Resistive-Capacitive
-Power Consumption: < 0.8W
-Range: up to 50m (outdoors) and 30m (indoors)
-Dimensions (LxWxH): 43 x 38 x 22mm